The Godlyke IP-1 Iso Pump voltage converter is an inline step-up converter that accepts 9 volts DC. The Iso-Pump increases the selectable voltages to 12, 18, or 24 volts DC at specific current values (see chart below). The IP-1 output voltage is determined by position of the 3-way switch located on the unit’s chassis. The IP-1 Iso Pump was designed to operate with Godlyke's PA-9 Power All digital power supply only. Voltage Input is standard polarity, Tip negative/Barrel positive. Female barrel connector and Output is standard polarity, Tip negative/Barrel positive, male barrel connector
Godlyke Power All IP-1 Power Pump Specs
In: 9 VDC @ 1700 mA (recommended)
Out: 12 VDC (.65 A) - 18 VDC (.44A) -
24 VDC (.33 A) @ 5%
Power Rating: 7.83 W continuous
Polarity: Tip Negative/Barrel Positive
Directions for Use:
Attach the Godlyke IP-1 directly to the Godlyke PA-9 or to a lead on the Cable-5 Daisy Chain Set the PP-9 to the required voltage – It can only supply 1 voltage at a time.
Make sure you check the polarity and voltage of the unit to be powered before connecting it to the Power Pump. Connect the PP-9 to the unit (s) to be powered - You can power multiple units off each PP-9 as long as you do not exceed the max Current per voltage listed above.
You can power up to 2 PP-9’s off one PA-9